Since I hate to scrub, our grasp toilet bathe has taken an actual hit. Once we purchased our home, it had a gorgeous, new bathe with tile and a glass encompass. Nonetheless, I did not understand how tough it will be to maintain that bathe glass clear from cleaning soap scum. As you possibly can see under, it was wanting fairly dangerous!
I’ve tried a number of retailer purchased cleaners previously, however they by no means did an excellent job on the glass doorways. So, I believed I might do this DIY Rest room Cleaning soap Scum Remover to see how widespread, on a regular basis components would do in cleansing a tricky cleaning soap scum problem. It got here out the cleanest I’ve seen our bathe since we purchased our home.
Please word: when you’ve got tile in your bathe, attempt to keep away from spraying the DIY combination on the tile since vinegar can injury grout over time.
Here is how my bathe glass door regarded earlier than I used the DIY Rest room Cleaning soap Scum Remover. Sure, I do know…it is tremendous soiled.
First, I combined the vinegar and corn starch in my glass measuring cup and microwaved for two minutes. Then, I added the Daybreak to the combination and poured it into an empty spray bottle. I waited so as to add the Daybreak till after microwaving, since in any other case it will begin foaming when it boiled.
In my bathe, I liberally sprayed the glass doorways and fiberglass pan on the backside of my bathe after which set the timer for 10 minutes. I ran my exhaust fan for the reason that vinegar and Daybreak scent might be fairly potent.
After 10 minutes simply scrub the ground and glass partitions with a sponge after which rinse with the showerhead and a sprig bottle full of water. Lastly, I used a clear towel to dry all surfaces to keep away from streaks.
You possibly can see from the after image above that it labored nice with a minimal quantity of bodily labor on my half!
Supplies
- 1 cup Distilled White Vinegar
- 1 tbsp. Corn Starch
- 2 tbsp. Daybreak Detergent
Directions
- Mix the vinegar and corn starch in a microwave-safe container (I used my glass measuring cup) and microwave for two minutes.
- Then add the Daybreak to the combination and pour into an empty spray bottle. Remember to wait till after heating the vinegar and corn starch so as to add the Daybreak since it is going to begin foaming should you warmth it (because the combination begins to boil).
- Liberally spray the glass doorways and fiberglass pan on the backside of your bathe
- Set the timer for 10 minutes. Though the components are pure, you’ll want to run your exhaust fan for the reason that vinegar and Daybreak scent might be fairly potent.
- After 10 minutes simply scrub the ground and glass partitions with a sponge
- Rinse with the showerhead and a sprig bottle full of water.
- Use a clear towel to dry all surfaces to keep away from streaks.
Take a look at extra Simple DIY Cleansing suggestions or observe my Cleansing board on Pinterest!